Wet Process Sensors
E32-L11FP/E32-L1  FS/E3X-DA   TG-S
Stable Detection of Glass in Wet Processes. Non-contact Operation Simplifies Mounting and Maintenance.
x; " >
|Output||NPN open-collector outputs||PNP open-collector outputs|
|Power supply voltage||12 to 24 VDC ± 10%, ripple (p-p) 10% max.|
|Power consumption||960 mW max. (cu|
rrent consumption: 40 mA max. at power supply voltage of 24 VDC)
|Control output||Load power supply voltage: 26.4 VDC, load current: 50 mA max.;|
residual voltage: 1 V max.
|Response time||Tough Mode (TG):|
Operate/reset in 16 ms each, Super Tough Mode (STG): Operate/reset in 64 ms each
Standard Mode (STND):
Operate/reset in 1 ms each, High-resolution (HRES) Operate Mode/reset in 4 ms each
|Timer function||On-delay/OFF-delay timer, OFF-delay timer, ON-delay timer, one-timer shot|
1. The factory settings are the U.S. follows: Tough Mode with an ON-delay/OFF-delay timer.
2.Be sure to check the chemicals and sprays used in the ambient environment before usingthe Wet Sensor.
Application No. 266
Accurately Detects Events Where Glass Cleaning Liquids Are Present in a Wet Process
This Fiber Sensor detects the passage of glass substrates in the cleaning process of glass substrates. This Sensor resists cleaning liquids and does not need mechanical adjustments to enable easy positioning adjustments with glass in a wide detection area. A special Fiber Sensor that mounts the new "Tough Mode "eliminating interference from water droplets enables stable detection that resists the spray of liquids.